Skip to content Skip to sidebar Skip to footer

6+ Shovelhead Starter Solenoid Problems For You

Shovelhead Starter Solenoid Problems. Intermittent operation can be a sign of a failing starter solenoid. You don't need to take your starter out.

1988 fxrs starting problem FIXED Harley Davidson Forums
1988 fxrs starting problem FIXED Harley Davidson Forums from www.hdforums.com

Starting problems on shovelhead this is on a shovel with the starter shifter arm, solenoid (plunger type) mounted 90 degrees to the starter on the inner primary, hitachi. For the evo guys with solenoid built on starter it is a common problem for the brass washers in the solenoid to stick together the fix is to take the end cap off remove the. For your shovelhead to start correctly, the starter relay wire must be connected to the s part of the solenoid.

I Rebuilt The Starter Solenoid On My 1977 Flh Harley Davidson Shovelhead, Then Realized The Plunger Boot Was Shot So Here's A Video On The Reassembly.


Starting problems on shovelhead this is on a shovel with the starter shifter arm, solenoid (plunger type) mounted 90 degrees to the starter on the inner primary, hitachi. For the evo guys with solenoid built on starter it is a common problem for the brass washers in the solenoid to stick together the fix is to take the end cap off remove the. I disconnected the starter relay cleaned it up put back on and it works.

For Your Shovelhead To Start Correctly, The Starter Relay Wire Must Be Connected To The S Part Of The Solenoid.


If it is spinning the starter is ok and the bendix (starter clutch) is shot. Check to see if there's 12.8 volts at the small (green) wire on the solenoid when ya push the start button. There are 4 most common starter solenoid problems.

Safe Payments Trusted Ssl Protection.


When starting it yesterday, i had to push the starter button 5 times before it turned. The bendix is inside the. I have owned a 1981 shovelhead flh since it was new.

No Hassle Exchanges 30 Day Return Policy.


Harley davidson starter & solenoid rebuild housemade 62.2k subscribers subscribe 858 93k. Intermittent operation can be a sign of a failing starter solenoid. Like he said, most likely is your battery.

Because After Replacing The Copper Washer And Everything Else The Manual.


Other issues that presen t a bad solenoid. Mine would kick the starter on till i got the battery disconnected or it melted the positive cable. Problems that might cause your car to act like it has a bad starter solenoid can.

Video Shovelhead Engine - Starter Solenoid Repair